Dodge Stealth 1995 Remote

Remote Programming Methods

Method A

1. Press and hold both the lock and unlock buttons for 4 seconds (or until the key LED flashes 4 times).
2. Release both buttons and wait 1 second.
3. Press and hold the lock button for 2 seconds (or until the LED flashes twice).
   → If successful, the key will flash once and/or the tester will confirm the remote has been programmed.

Method B

• Press either the lock or unlock button 3 times within 5 seconds.

Method C

1. Press and hold both the lock and unlock buttons for at least 1 second.
2. Release both buttons and wait 1 second.
3. Press the unlock button.

Method D (Connect pins 1 and 4 on the OBD connector manually, or use a ready-made adapter such as ADC194.)

OBS: Most common procedure for separate remotes!

1. With ignition OFF connect pins 1 and 4 of the OBD connector together using a suitable jumper pin (or adapter).
2. Turn the ignition ON.
3. Press the hazard light switch 6 times.
4. Press the lock and unlock buttons alternately twice.

Method E (Connect pins 1 and 4 on the OBD connector manually, or use a ready-made adapter such as ADC194.)

1. Ensure the doors lock and unlock using the key.
2. With ignition OFF connect pins 1 and 4 of the OBD connector together using a suitable jumper pin.
3. Within 10 seconds of connecting the jumper switch ignition from OFF to ACCESSORY 3 times within 2 seconds.
4. The doors will LOCK and UNLOCK.
5. PRESS the LOCK or UNLOCK button on the first remote transmitter 3 times within 10 seconds of the first press.
6. The doors will LOCK and UNLOCK.
7.  Repeat step 5 for additional remote transmitters.
8. REMOVE Jumper connection.
9. Check all remote transmitters for correct operation.

NOTE : ALL remote transmitters must be programmed within 1 minute of entering the programming mode.

NOTE : Programming mode will end when 4 transmitters are programmed, Jumper is disconnected or Ignition is switched ON.