Isuzu D-Max 2019 Remote Key
Remote Key (ID46+TOY43R)
Overview
Key Type
Remote Key
Markets
EU, MEA, AUO, ASIA
Transponder
ID46 (PCF7936 / HITAG 2)
Separate
Frequency
434 MHz
Battery
CR2016
Transponder Cloning
Yes
Skill Level
Beginner
Universal Keys
Xhorse 433 MHz: ID 0557 209 or ID 0551 320 or ID 0534 941 or ID 0535 197 or ID 0551 320
Not tested
Overview
Add key
OBD
All keys lost
OBDEeprom/Bench
Prepare dealer key
Not specified
Remote programming
Manual
All keys erased automatically
Not specified
Power supply
Recommended (if under 11.5V)
Additional cables required
No
Key Programming via OBD
General Instructions
- The remote is programmed manually.
- With all keys lost, programming must be done via eeprom.
Remote Manual Programming
- Enter the vehicle and CLOSE the drivers door.
- Insert the key into the ignition lock.
- OPEN the drivers door.
- Turn the ignition key from the OFF to the ON position 3 times, ending in the OFF position.
- CLOSE and OPEN the drivers door twice, ending in the open position.
- Wait 5 to 8 secs.
- Turn the ignition key to the ON and OFF position twice.
- Remove the key from the ignition.
- Close the drivers door.
- Wait for the hazard lights to flash 3 times (indicating programming mode).
- Press the UNLOCK button 3 times on the remote control quickly.
- Hazard lights will blink once to indicate successful programming of the remote control.
- Repeat step 11 to 12 for each extra remote control to be programmed.
- Insert the ignition key in the ignition lock and turn the key to the ON position.
- The hazard lights will flash 3 times indicating the end of the programming mode.
- OPEN and CLOSE the drivers door.
- Test remotes.
Programmers
Autel
Immobilizer Programming
Abrites AVDI
Immobilizer Programming
Xhorse
Immobilizer Programming
TDB1000
Not supported
Code Series
0000-5928 (Chevrolet, Holden, Isuzu) 10-10 Cuts 70000-75928 (Chevrolet, Holden, Isuzu) 10-10 Cuts 022000-022999 (Isuzu) 10-10 Cuts
Overview
Double locked
No
Opening direction (LHD)
Counter-clockwise
Decoder capability
Door LockIgnitionBoot/Trunk
Decoding Tips
- There is separate Lishi tool for ignition and door locks.
- To decode the lock read in the SAME direction as it was picked.
- Adjacent cuts WITHIN the pairs must be no more than one depth apart.
- Adjacent cuts BETWEEN the pairs must be no more than two depths apart.
- No more than three consecutive cuts of the same depth.
- Number stamped on some wafers are opposite to its corresponding cut depth.
Overview
Original key glued
No
Synchronizing
No
Repair Instructions
- Key has a separate immobilizer chip.
- There is no need to synchronize or reprogram the key after replacing the battery.
Media
