Isuzu Elf / N series 2008 Remote Key
Isuzu Remote Key ID46 TOY43R Truck
Overview
Key Type
Remote Key
Markets
EU
Transponder
ID46 (PCF7936 / HITAG 2)
Separate
Frequency
433 MHz
Battery
CR2032
Transponder Cloning
Yes
Skill Level
Skilled
Overview
Add key
OBD
All keys lost
OBDEeprom/Bench
Prepare dealer key
No
Remote programming
Manual
All keys erased automatically
Not specified
Power supply
Recommended (if under 11.5V)
Additional cables required
No
Remote Manual Programming
Starting State:
Key out of ignition
All Doors Closed and unlocked
Complete Step 1-3 within 10 seconds
Step 1: Open Drivers Door
Step 2: Lock and unlock drivers side manual slide
Step 3: Insert key into ignition
Step 4: Turn Key on then off 2x
Step 5: Remove key from ignition
Step 6: Press the door ajar switch 6x
Locks will cycle 2x
Step 7: On the remote, press and release lock and unlock buttons together
Step 8: On the same remote press and release lock or unlock button
Locks will cycle
Close the drivers door to exit programming
Check remotes
To Delete Remotes
Step 1: Open drivers door
Step 2: Lock and unlock drivers side manual slide
Step 3: Insert key into ignition
Step 4: Turn Key on then off 6x
Step 5: Remove key from ignition
Step 6: Press the door ajar switch 7x
Hazards will flash 5x
Close drivers door
All remotes are now cleared
Code Series
0000-5928 (Chevrolet, Holden, Isuzu) 10-10 Cuts 70000-75928 (Chevrolet, Holden, Isuzu) 10-10 Cuts 022000-022999 (Isuzu) 10-10 Cuts
Overview
Double locked
Not specified
Opening direction (LHD)
Not specified
Decoder capability
Door LockIgnitionBoot/Trunk
Decoding Tips
- There is separate Lishi tool for ignition and door locks.
- To decode the lock read in the SAME direction as it was picked.
- Adjacent cuts WITHIN the pairs must be no more than one depth apart.
- Adjacent cuts BETWEEN the pairs must be no more than two depths apart.
- No more than three consecutive cuts of the same depth.
- Number stamped on some wafers are opposite to its corresponding cut depth.
Overview
Original key glued
Not specified
Synchronizing
Not specified