Jaguar XJ 2007 Remote Key
Jaguar Remote Key ID60 FO21
Overview
Key Type
Remote Key
Markets
EU, USA, SA, ASIA, AUO
Transponder
ID60 (Texas 4D60)
Separate
Frequency
315 MHz433 MHz
Battery
CR2032
Transponder Cloning
Yes
Skill Level
Skilled
Universal Keys
Xhorse 315 Mhz: ID 0547 738
Not tested
Xhorse 433 Mhz: ID 0547 482
Not tested
Overview
Add key
OBD
All keys lost
Eeprom/Bench
System
CAN
Prepare dealer key
No
Remote programming
Manual
All keys erased automatically
Not specified
Power supply
Recommended (if under 11.5V)
Additional cables required
No
Key Programming via OBD
General Instructions
- The car has memory slots of a four keys.
Jaguar XJ Remote Programming (manual)
Remote Manual Programming
Jaguar X-type manual remote programming procedure:
- Put key into ignition.
- Turn to position I.
- Turn key between position I and II four times.
- On the fourth turn back to position I the sounder will chime to indicate the car is in programming mode.
- Remove key from ignition.
Programmers
Autel
Remote Programming
Abrites AVDI
Not supported
Xhorse
Not supported
Code Series
(T......) 1234 (Ford, Jaguar, Mazda, Merkur, Aston Martin) T1051-T2330 (Ford, Jaguar, Mazda, Merkur, Aston Martin) T1-T1050 (Ford, Jaguar, Mazda, Merkur, Aston Martin)
Overview
Double locked
Not specified
Opening direction (LHD)
Not specified
Decoder capability
Door LockIgnitionBoot/Trunk
Decoding Tips
- The lock has 6 spaces and 4 depths.
- Every lock has atleats one number four cut.
- Door lock turns to lock position with all tibbe keys regardless of the cutting.
- The same six cuts on all four sides of the key.
- The decoder has 6 pairs of legs, and each of them will need to be rotated to find the correct depth of that position. Your first step will be to find the #4 cut disc and to apply firm pressure on it. Then proceed through all the other positions while gently applying constant counterclockwise pressure on the #4 disc.
- With the lock open, draw the line based on #4 to read the cutting (picture "Decoding").
- Decoder jammed while lock removed: use a screwdriver to press on the indicated area in the picture "Tool removal 1", then easily pull decoder out of the lock.
- Decoder jammed while lock not removed: slide a very thin pick (picture "Tool removal 2") on the underside of the key and push the key back into the lock along with the pick, now hold the pick in place and slide out the key or tool.
Media
Decoding
Tool removal 1
Tool removal 2
Overview
Original key glued
No
Synchronizing
Yes