Infiniti G Line 2001 Remote
Nissan Remote
Overview
Key Type
Remote
Markets
EU
Transponder
ID33 (PCF7935 / Philips 33)
Separate
Frequency
418 MHz
Battery
CR1620
Skill Level
Beginner
Overview
Add key
OBD
All keys lost
OBDEeprom/Bench
System
NATS 2
Prepare dealer key
Not specified
Remote programming
Manual
All keys erased automatically
Yes
Power supply
Recommended (if under 11.5V)
Additional cables required
No
Number of key slots
4
Key Programming via OBD
General Instructions
- 14 Pin OBD
Key Programming via EEPROM
NATS 2
Original transponder: 7930 (ID33)
Allowed transponder: 7930,31,35
Unit location:
- Nissan Micra - inside the right pilar (removal of the central panel required)
- Nissan Almera - above the pedals (right side)
- Rest models - above the pedals
Data location:
- Unsecured MC68HC05B8 (Mask 3D33J)
- Unsecured MC68HC05B8 (Mask 0F10V)
Reading:
- V1 - In circuit using 05 KL-CAN adapter from Orange5
- V2 - Out circuit using HC05B adapter
No. of keys: 4
Unit location
Nats 2
Reading V1
Reading V2
Remote Manual Programming
- Switch ignition from position 0 to ON 6 times within 10 seconds.
- Switch ignition OFF, but leave key in ignition.
- After 2 seconds the vehicle will enter programming mode and will flash the warning lights twice.
- PRESS and HOLD the UNLOCK button on the first remote transmitter, and PRESS the LOCK button 3 times.
- RELEASE the UNLOCK button.
- The warning lights will flash once to confirm remote transmitter is programmed.
- Repeat steps 4 to 6 for additional remote transmitters.
- Once complete, switch ignition ON and warning lights will flash 2 times.
- Check all remote transmitters for operation.
Programmers
Orange5 + Tango
Recommended
EEPROM/Bench Programming
Smart Pro
Immobilizer Programming
Autel
Immobilizer Programming
EEPROM/Bench Programming
Xhorse
Immobilizer Programming
EEPROM/Bench Programming
Abrites AVDI
Not supported
Code Series
1-8000 (Ford, Nissan) 8-8 Cuts X1-X8000 (Datsun, Nissan) 8-8 Cuts X8001-X9000 (Datsun, Nissan, Subaru) 8-8 Cuts
Media
Key cutting with Xhorse
Overview
Double locked
Not specified
Opening direction (LHD)
Not specified
Decoder capability
Door LockIgnitionBoot/Trunk
Decoding Tips
- Wafers are not stamped/numbered The lock has 8 spaces and 4 depths.
- The same eight cuts on both sides of the key.
- Wafers are not stamped/numbered.
- To decode the lock read in the SAME direction as it was picked.
Overview
Original key glued
No
Synchronizing
No
Repair Instructions
- Separate remotes do not house immobilizer chips.
- There is no need to synchronize or reprogram the key after replacing the battery.