Jaguar XF 2009 Slot Key
Smart Key
Overview
Key Type
Slot Key
Markets
USA, EU
Transponder
ID46 (PCF7953A / HITAG 2)
Integrated
Frequency
315 MHz433 MHz
Battery
CR2032
Transponder Cloning
Yes
Skill Level
Skilled
Original Keys
C2P17156 (FSK): Jaguar XF
Direct Programming to another vehicle
Overview
Add key
OBD
All keys lost
Eeprom/Bench
Prepare dealer key
No
Remote programming
Automatic
All keys erased automatically
Yes
Power supply
Mandatory
Additional cables required
No
Key Programming via OBD
General Instructions
- When programming a new key in the key slot, don't push the key all the way in, so it doesn't get stuck.
- When programming proximity key (remote) pressing the start button is only necessary to "wake up vehicle" the ignition does not have to be on, you could also switch on hazard lights to do this.
- In the event of the vehicle shutting down and keys not working once programmed, disconnect negative battery terminal for around 5-10 minutes then reconnect battery.
- PROX functions are disabled when the key is placed in the emergency transponder (SCU) reader
- If the emergency start (from slot) doesn't work with new key after programming - contact technical support for the solution.
OBD Location
Located above the pedals on the left
Emergency Key Spot
Left side (right side for UK) close to the drivers door. Note! Before operating make sure the emergency blade is fitted in the key shell - otherwise might be tricky to pull it out of the slot.
Programmers
Abrites AVDI
Immobilizer Programming
Remote Programming
Autel
Remote Programming
Xhorse
Remote Programming
Lonsdor K518 PRO
Remote Programming
Smart Pro
Remote Programming
Code Series
1-4000 (Ford, Land Rover, Range Rover)
Media
Emergency Key (C2Z3903/C2P2650)
The original key is made of aluminum (take this into account when cutting or working on it). Metal aftermarket keys are also available.
Overview
Double locked
Yes
Opening direction (LHD)
Clockwise
Decoder capability
Door LockBoot/Trunk
Decoding Tips
- There will never be more than 2 height differences between wafers next to each other.
- Picking this lock requires a very light turning tension.
- No keys contain a depth #1 in the first position.
- All keys contain a depth #2 in the last position.
- There are only five possible cut combinations for the last three positions: 132 (28%), 532 (22%), 312 (20%), 232 (16%), 422 (14%)
- Lishi 2-in-1 decoder for 10 cuts works also for 8 cut locks.
- To decode the lock, read in the SAME direction as it was picked.
Overview
Original key glued
No
Synchronizing
No
Repair Instructions
- All smart keys have an integrated immobilizer chip.
- There is no need to synchronize or reprogram the key after replacing the battery.
Media
Shell and battery change
A common issue with battery holder
A common issue or weak point with these keys is the battery holder coming loose from its solder joint. This affects both original keys and even some new aftermarket ones. The solution is to reinforce or re-solder the connection.
BAttery Chnage (Owners Manual)
Circuitboard
PCB
