Isuzu Ascender 2005 Remote
GM Remote MYT3X6898B
Overview
Key Type
Remote
Markets
USA
Frequency
315 MHz
Battery
CR2032
Skill Level
Beginner
Universal Keys
Xhorse ID 0540 574
Test passed
KeyDiy ID R00221
Not tested
Original Keys
MYT3X6898B 3Buttons
Direct Programming to another vehicle
Overview
Add key
Not specified
All keys lost
Not specified
Prepare dealer key
Not specified
Remote programming
Manual
All keys erased automatically
Yes
Power supply
Not specified
Additional cables required
Not specified
Remote Manual Programming
NOTE Make sure the power is OFF and the driver's door is open
NOTE This instruction must be completed within two minutes
- Insert and remove key from ignition TWICE.
- CLOSE and OPEN the driver's side door TWICE - leaving the door in OPEN position.
- Insert and remove key from ignition ONCE.
- CLOSE and OPEN the driver's side door TWICE - leaving the door in OPEN position.
- Insert the key and close driver door.
- Press the START/STOP button THREE times. Do not start the vehicle.
- Remove the key from ignition. Door locks will cycle ONCE to indicate programming mode is active.
- PRESS and release both LOCK and UNLOCK buttons on the remote control for 2 seconds.
- PRESS and release the LOCK button on the remote control for one second. Door locks will cycle ONCE to indigate successful programming. (NOTE: if the locks cycle TWICE remote control might be incorrect for the vehicle).
- Repeat steps 8 and 9 for any additional remotes.
- Turn ignition ON and OFF to exit programming mode.
Programming instructions for Buick, Cadillac, Chevy, GMC and Hummer up to 2007
Video by carandtruckremotes
Overview
Double locked
Not specified
Opening direction (LHD)
Not specified
Decoder capability
Not specified
Overview
Original key glued
No
Synchronizing
No
Repair Instructions
- Separate remotes do not house immobilizer chips.
- There is no need to synchronize or reprogram the key after replacing the battery.
Media
Shell and battery change
Circuitboard
MYT3X6898B PCB
