Infiniti I30/I35 2003 Remote
Infiniti Remote US
Overview
Key Type
Remote
Markets
USA, SA
Transponder
ID46 (PCF7936A / HITAG 2)
Separate
Frequency
315 MHz
Battery
CR2025
Transponder Cloning
Yes
Skill Level
Beginner
Overview
Add key
OBD
All keys lost
OBD
System
BCM
Prepare dealer key
Not specified
Remote programming
Manual
All keys erased automatically
Yes
Power supply
Not specified
Additional cables required
Not specified
Key Programming via OBD
General Instructions
- Programming the immobilizer requires a PIN code. If you cannot read it directly, check the codes on the BCM label and use the device’s calculator to determine the PIN code.
Remote Manual Programming
- Close and lock all doors with the drivers side power lock/unlock switch.
- Insert key into ignition and remove it from the ignition key cylinder at least eight times within 10 seconds. Your Hazard Lamps will flash if you have performed this step successfully.
- Insert key into the ignition cylinder and turn to the ACC position.
- Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should flash. NOTE: Do not press the button more than one time in the above step.
- If there are any remaining transmitters (including the old ones), unlock then lock all doors using the drivers side power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should flash. Repeat this step for each transmitter (including any existing transmitters).
- Turn the key to the OFF position, remove keys from the ignition, unlock doors using the power lock/unlock switch and open the driver side door.
- Test the remotes
Code Series
00001-22185 (cuts: 10-10, card: 220, ISN: 2354)
Media
NSN14 key cutting with Xhorse
Overview
Double locked
Not specified
Opening direction (LHD)
Counter-clockwise
Decoder capability
Door LockIgnitionBoot/Trunk
Decoding Tips
- To decode the lock read in the SAME direction as it was picked.
- No keys use a #1 depth in the last position. (1-22185)
- No keys contain the same depth in more than 3 adjacent positions. (1-22185)
- No keys contain the same depth in more than 5 positions. (1-22185)
- No keys contain a #4 depth in the first two positions. (1-22185, 30001-37850)
- There are only four possible cut combinations for the first two positions: 1-2; 2-1; 2-3; 3-2. (1-22185)
Media
8 Cut NSN14 Lishi Picking & Decoding
Video by Bored lock picker
Which NSN14 Lishi to Use 10 Cut vs 8 Cut
Video by Bored lock picker
Overview
Original key glued
No
Synchronizing
Yes
Repair Instructions
- Separate remotes do not house immobilizer chips.
Circuitboard
Remote KBRASTU15 PCB
